Thread: Newbie Question ...
-
03-12-2009 #1
Hi Folks, While reading and inwardly digesting every bit of information re CNC before I decide which way to go, I came across this ... Flying or Terrain following Head my question is what is the difference? My knowledge of Terrain following comes from low altitude flying in helicopters ... 'if you do not follow the terrain, you will not be flying as you will have come into contact with the terrain.
RegardsTim G-C
“I disapprove of what you say, but I will defend to the death your right to say it.”
(attrib. Voltaire but written by Evelyn Beatrice Hall "The Friends of Voltaire" 1906)
-
I think you are talking engraving.
The flying head is positioned in X, Y and Z
The terrain following head is powered on X and Y but rests on the Z, thereby cutting a constant depth even if the surface is sloped or gently corrugated.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Newbie computer hardware question
By chris in forum Computer HardwareReplies: 4Last Post: 16-01-2014, 05:12 PM -
NEW MEMBER: Newbie - question on bit types
By Steven W in forum New Member IntroductionsReplies: 2Last Post: 16-05-2013, 12:06 PM -
FK12 BEARING, tighten on lead screw first - newbie question?.
By Mark Snape in forum Lead Screws, Nuts & SupportsReplies: 4Last Post: 08-03-2012, 10:59 AM -
newbie with a tool id question
By bigmatt-s2rst in forum Tool & Tooling TechnologyReplies: 2Last Post: 03-10-2011, 06:16 AM -
question ...
By Wobblybootie in forum General DiscussionReplies: 6Last Post: 04-01-2010, 12:04 AM
Bookmarks