Missing information for Mach3 settings

[ZASto]

Hi JAZZCNC
Friday? Pub?
Mach3 knows nothing about USB, so definitely the board is an motion controller.
On the picture:
http://www.mycncuk.com/attachment.ph...811440&thumb=1
is clearly visible a micro controller (no matter which type but looks as some STM32Fxxxx).
So, motion controller with BOB :)

[JAZZCNC]

Hi JAZZCNC
Friday? Pub?
Mach3 knows nothing about USB, so definitely the board is an motion controller.
On the picture:
http://www.mycncuk.com/attachment.ph...811440&thumb=1
is clearly visible a micro controller (no matter which type but looks as some STM32Fxxxx).
So, motion controller with BOB :)

Hi ZASto, No not the pub but I am not myself today, poorly sick and dying from food poisoning, ate some dodgy fish I think..

To be honest I didn't look that close to see it only had USB and no PP. I don't use BOB's these days and most I've seen like this have a USB port so just assumed it was standard BOB,!! , , , , You know that they say about assumptions being the mother of all FKUP's ...