Threaded View
-
26-07-2021 #1
Hello fellow members.
Just want to get a 2nd opinion on this wiring diagram below.
12 proximity sensors going into a 12 channel isolation board at 24v.
Then going out of the isolation board at 5v.
Then going from board directly into an input based LPT port of my cnc controller.
Sensors: NPN, NC, operating at 24v.
Isolator board designed for 24v/in & 5v/out.
LPT is port 5 of a UC300eth controller running at 5v.
Diagram:
Yes it would be easier to get a bi-directional bob for it but we're talking about the u.k. here.
You can't get Jack.
(Anyway. The multi isolator boards look neater and are easier to get)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Wiring Diagram check
By eurikain in forum Electronic Project BuildingReplies: 81Last Post: 08-12-2017, 08:40 PM -
Which wiring diagram software do you use ?
By eurikain in forum Computer SoftwareReplies: 3Last Post: 11-10-2015, 02:48 PM -
VFD Wiring Diagram
By Tomnewry in forum General ElectronicsReplies: 9Last Post: 14-10-2013, 06:46 PM -
Wiring diagram for 4x4 cnc router
By Danielroyal25 in forum General ElectronicsReplies: 1Last Post: 19-07-2013, 11:14 PM -
NEW MEMBER: Hi, Looking for a wiring diagram, Melbourne
By Sampop in forum New Member IntroductionsReplies: 1Last Post: 28-10-2010, 11:18 AM
Bookmarks