Thread: Will run out of HAIR SOON
Threaded View
-
31-07-2021 #1
Hi all,
please can someone help me.
Finished build (mech +elec) of my CNC with spindle.
Got no movement -
Using Mach 3 on Win 7, Parallel port on PCI.
Did fresh install of Win 7, and then Mach 3 on a fresh hard drive.
Was prompted by means of a tick for PP (parallel port) driver - ticked.
Question: in device manager i dont have resources to show address for PP, also says my driver for the card is not there - tried and cannot get a new driver for the PP loaded? Any ideas
Have been through all the inputs/outputs etc on config - nothing changes
Checked continuity from PP male - PP female (i had to cut it to go through a gland) - all tested ok.
i did have limit switches illuminate (on and off) on diagnostics page - so i assume the link between BOB and PC is ok.
i am using a BB5001 board (HY-JKM5) Chinese one off Ebay, found a couple of articles which showed pin allocation - does anyone know what they should be?
Starting to think that this is the root of all my problems.
Any help/info greatly received.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
NEW MEMBER: Will run out of HAIR SOON
By 703E5 in forum New Member IntroductionsReplies: 1Last Post: 31-07-2021, 07:27 PM -
need a part... and pulling my hair out now
By flotsam in forum Lead Screws, Nuts & SupportsReplies: 18Last Post: 19-04-2021, 04:12 PM -
pulling my hair out with cam
By universally in forum CAD & CAM SoftwareReplies: 6Last Post: 09-04-2015, 01:41 PM -
Hair growth device. DIY version
By gavztheouch in forum Electronic Project BuildingReplies: 16Last Post: 30-03-2014, 08:55 PM -
AM882,s and Mach3 ......plus hair removal !!!
By Buba b in forum Motor Drivers & ControllersReplies: 3Last Post: 26-10-2012, 05:11 PM
Bookmarks