. .
  1. #1
    I have been working on my first ever fixture and I am so close to having it complete.My problem is that my part won't fit into my fixture correctly,the bottom left corner sits higher than than the other corners which sit Flat.Im try to achieve a
    good fit so my part sits tight,my fixture is 5microns bigger than the part.Iv tried deburring,offsetting my wall width where my part is raised,amongst several other things,any suggestions will really help.

  2. #2
    What material is the fixture made from.?
    What material is the part.?
    What type of machine.? Mill or Router.
    What type and material is the bed made from.?

    Do you know if your part is flat or for that matter your fixture is truly flat or even the surface the fixture fastens down to is flat.? If any of them has any twist you will struggle to get a perfect fit.
    Usually, you would surface the fixture so it's co-planer to the spindle, then you would machine the mating surface of the part if you need a close fit to the fixture.

    If you have removed all burrs then I would suspect a twist in any of the areas mentioned above and most likely a little in each.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FOR SALE: Fixture plate
    By GOOSEISLAND in forum Items For Sale
    Replies: 5
    Last Post: 05-06-2020, 03:34 PM
  2. Tooling Fixture Plate for Milling Machine - guidance requested
    By GND in forum Milling Machines, Builds & Conversions
    Replies: 10
    Last Post: 16-04-2020, 11:19 AM
  3. Fixture advice
    By Voicecoil in forum Metalwork Discussion
    Replies: 8
    Last Post: 10-04-2020, 09:42 PM
  4. Flat bar or plate for CNC
    By dfox1787 in forum Metalwork Discussion
    Replies: 18
    Last Post: 25-05-2018, 06:46 PM
  5. WANTED: Rotating Nut Fixture x2
    By PaulP in forum Items Wanted
    Replies: 13
    Last Post: 02-01-2018, 10:50 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •