Hybrid View
-
21-08-2021 #1
Hi, I've done the ramp test and set the z height accordingly. I use the air assist, I've tried it on full air flow and restricted but it didn't seem to make much difference. I'm using the compressor supplied with the laser.
I'm not sure about the paper tape on the bed, I think I'd only get a dot as it's focused at that point?
Thanks
-
21-08-2021 #2
It seems that at the points that the material is melted, that the beam is focused at a different height than at the rest of the material.
What I mean is that the beam is focused higher or lower.
Did you try to cut something else? That melt happened at the same distance from XY 0 on the new material?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Cutting Acrylic
By Britannicus1 in forum General DiscussionReplies: 4Last Post: 04-02-2020, 11:50 PM -
RFQ: laser cut acrylic panels
By mnewsholme in forum Projects, Jobs & RequestsReplies: 0Last Post: 08-06-2019, 12:46 PM -
Which cutting tool on acrylic?
By piper1 in forum Machine DiscussionReplies: 7Last Post: 06-07-2017, 11:12 PM -
Acrylic Cutting Help
By Tenson in forum Machine DiscussionReplies: 26Last Post: 08-11-2016, 08:15 PM -
Laser cutting 10mm acrylic?
By camhguh in forum Laser Machines & BuildingReplies: 14Last Post: 04-09-2012, 12:51 AM
Bookmarks