. .
Page 2 of 2 FirstFirst 12
  1. #11
    Quote Originally Posted by terry1956 View Post
    Hi jazz, I fitted a closed loop motor and driver to my last machine, and it did not like it. It may of been that I only used it on one axis. But it could of been me. However I have read on a few forums that people have had a few problems. I think if ever I get this mill working as it should I will fit closed loop on all axis.
    Hi Terry, I can assure you 100% that the Cslabs or any other open-loop Step/Dir controller for that matter knows nothing about the drive which is attached, they just send out pulses and trust the drive receives them. Now, you can get drives that handle pulses timings differently but I've yet to see a Closed-loop drive or any drive for that matter that doesn't work with the Cslabs controller. However, pulse timing issues can usually be dealt with in the control software motor tuning.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk

  2. #12
    All sorted now. It was a bad stepper driver coursing the problems.

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: You need a CNC to make a CNC.
    By quadrilateral in forum New Member Introductions
    Replies: 4
    Last Post: 25-04-2017, 08:13 PM
  2. Replies: 4
    Last Post: 26-04-2013, 08:37 AM
  3. How would you make these, or something near enough...
    By irving2008 in forum General Discussion
    Replies: 8
    Last Post: 22-09-2012, 09:36 PM
  4. Using Games Contoller with Mach3
    By cropwell in forum Artsoft Mach (3 & 4)
    Replies: 3
    Last Post: 01-08-2012, 12:13 PM
  5. How to make something like this?
    By lateAtNight in forum Machine Discussion
    Replies: 2
    Last Post: 13-05-2009, 08:16 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •