Threaded View
-
28-08-2021 #8
Regarding AXBB-E. People over on cnczone haven't been able to add 5th or 6th axis straight onto the additional IO fitted to the board. They are mainly all designed for switching. The way to do it is via port#3 with an additional UCSB or other bob.
I have the UC300eth with a UCBB. This setup limits you to 16 out and 18 in through 2 ports. You need an extra IDC16 cable and a terminal block for use of analoge port. Or you can plug directly with dupont cabling/connectors.
I prefer to use seperate components because if 1 fails it's cheaper to replace.
UB1 uses 3 ports + the analoge as standard giving more IO over the UCBB.
For the other 2 ports (4+5) there is the UD1 daughterboard. My view is that if something fails it will be a large cost to replace it again.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
New UC300ETH Breakout Board/Motherboard
By Ger21 in forum CNCdrive (UC100, UC300ETH)Replies: 10Last Post: 17-07-2019, 09:41 PM -
anyone using an e-cut 1 mhz usb breakout board
By nobby in forum Control Hardware & SystemsReplies: 10Last Post: 22-10-2018, 11:50 PM -
which breakout board?
By johngoodrich in forum General ElectronicsReplies: 4Last Post: 12-03-2017, 01:54 AM -
Breakout Board
By Tomnewry in forum General ElectronicsReplies: 2Last Post: 12-12-2013, 07:24 PM -
Breakout Board
By croy in forum Electronic Project BuildingReplies: 10Last Post: 18-08-2011, 07:50 AM
Bookmarks