Threaded View
-
31-08-2021 #1
Does anyone have experience repairing these Driver modules. The information avail online from Lenze and Boxford is (mushroom)
My spin (Chuck motor) did not start spinning when I turned machine on after a long period of non use. I have diagnosed problem to 534 driver board.
I have found a blown Rifa (Kermet) 150nF (0.15uF) 275V mains capacitor. This is mounted across a isolated power transformer which supplies 12volt and 3.5 volts to a daughter card mounted on edge of controller board. I can accept that old age and moisture would cause paper capacitor to fail especially when there is little margin for spikes in original 275V AC rated capacitor. I have ordered a higher rated new polyester capacitor that will fit but there may be other problems with the board. I am going to check and clean motor brushes today as it a good time to inspect brush lengths and clean commutator.
Does anyone have a full circuit diagram? --Or a working 534 module or board that they can sell me?Last edited by JohnnyK; 26-09-2021 at 01:44 AM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Problem with Boxford TCL lenze controller
By John11668 in forum General DiscussionReplies: 21Last Post: 23-02-2021, 12:34 PM -
Boxford 260VMC with toolchanger Lenze spindle speed issue/query
By swood1 in forum Boxford Vertical MillsReplies: 0Last Post: 27-03-2018, 03:18 PM -
Lenze 8200 VFD Inverter - Spindle motor not moving
By Fgc in forum Spindles & Drive MotorsReplies: 7Last Post: 13-11-2017, 02:34 AM -
FOR SALE: 4 Axis TB6560 Stepper Motor Driver Board
By Mad Professor in forum Items For SaleReplies: 1Last Post: 04-01-2011, 06:54 PM -
New SCR driver board, or new motor & VFD?
By m_c in forum Motor Drivers & ControllersReplies: 2Last Post: 04-11-2010, 05:16 PM
Bookmarks