Threaded View
-
02-09-2021 #4
Last Activity: 15-07-2024
I use a relay for the spindle star/stop but I just leave the water pump running all the time the VFD is turned on and use the other relay contact for start/stop of the dust extractor. Just an option for you to consider.
KitAn optimist says the glass is half full, a pessimist says the glass is half empty, an engineer says you're using the wrong sized glass.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AXBB-E any opinions?
By ngwagwa in forum Motor Drivers & ControllersReplies: 12Last Post: 21-07-2021, 04:32 PM -
moving from Mach3 to AXBB
By ngwagwa in forum CNCdrive (UC100, UC300ETH)Replies: 5Last Post: 12-04-2020, 10:01 AM -
looking for a pendant to work with Cslabs ip-m mach 3
By charlieuk in forum CS-Lab (CSMIO)Replies: 7Last Post: 22-09-2017, 03:56 PM -
Cheap CNC breakout board for controlling spindle speed, will this work?
By ROBCNCAU in forum Spindles & Drive MotorsReplies: 7Last Post: 04-08-2016, 02:48 PM -
Mach lathe spindle speed control
By GeoffV in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 21-05-2014, 08:34 AM
Bookmarks