Boxford 125 TCL - Mach3 Ports & Pins Spindle Configuration

[Reprobus]

The 24v box isn’t putting out any power for some reason, I’m unsure whether the DC converter is broke or whether a signal has to be received from Mach3 first before the box puts out the power. I shall investigate

My new BoB has now arrived, so before removing the old one I labelled all of the wires to eliminate errors. The layout of the ports on the new BoB is rather different from my old one, but unfortunately I can’t upload a picture.
Between ports 2 and 3 (for example) on my old BoB there is a port labelled “COM” which I presume is ground. This isn’t on my new board so I routed the wires around to another ground port on the side

After fitting all of the wires to the new BoB I powered up the machine and tried to jog the X and Z axis but there was no movement at all, nor from the lathe’s kill switch. I’ll re-fit the old one for now and focus on getting the spindle turning