. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 15-09-2021 #6
    Reprobus's Avatar
    Lives in Liverpool, United Kingdom.
    Reprobus
    Last Activity: 26-10-2021 Has been a member for 3-4 years. Has a total post count of 12.
    So I refitted my old BoB and I can now jog the X and Z axis’ again

    With this I decided to troubleshoot the 24v box and I have come to the conclusion that it is knackered. I’ve just ordered a replacement so I’ll hopefully have it fitted this time next week

    I will leave the old BoB installed as I know it works. Providing I can get my ports & pins/set up data sorted she should run
    Last edited by Reprobus; 15-09-2021 at 09:22 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. MK4 MACH3 Motion Card Problem with output control ports. NEED HELP!
    By Mushtantuk in forum Motor Drivers & Controllers
    Replies: 0
    Last Post: 18-06-2017, 02:36 PM
  2. Mach 3 ports and pins problems,
    By chris w in forum Artsoft Mach (3 & 4)
    Replies: 24
    Last Post: 06-04-2017, 03:25 PM
  3. Mach3 ports and pin setup to match my control box
    By Sparky in forum Artsoft Mach (3 & 4)
    Replies: 17
    Last Post: 13-11-2014, 04:00 PM
  4. ports and pins for system4
    By Dan Brown in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 18-01-2010, 06:37 PM
  5. Ports and pins help ? mach 3
    By xchipx in forum Artsoft Mach (3 & 4)
    Replies: 0
    Last Post: 19-04-2009, 12:45 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules