y axis motor mounting suggestions

[Clive S]

You could put a shim 1.5mm in the gap or machine the BK and BF mounting plate 1.5 thinner.

[reefy86]

You could put a shim 1.5mm in the gap or machine the BK and BF mounting plate 1.5 thinner.

Thanks Clive probably easier with shims then.

[Clive S]

You could put a shim 1.5mm in the gap or machine the BK and BF mounting plate 1.5 thinner.

You could also remake the top plate wider so the you bolt the ball nut plate down from the top and adjust it with slots in the top plate