Thread: Denford Triac Spindle Issue
Threaded View
-
29-09-2021 #8
Thanks for replies guys
(I’ve also got the thread running on the Denford forum… my thought was to cast the net wise to try and capture as much input as possible)
I had found fuse #F1 (spindle) to have blown…
I changed for a new 10A (as per wiring diagram I found for this year machine?)
Upon firing up the machine, the spindle ramps up to full revs and back down, to approx. 60-100revs, and stays there.
Once I reference the axis, I can stop and restart the spindle in manual mode, but can’t change the rpm??
I rebooted the machine and the same occurred…
I get 200mV across wires #54 & #55 at all revs.
Could defective brushes cause this?
Or more likely to be a drive issue or other?
@M_C… what was the cost of your drive and spindle, and where did you source this from?Last edited by GingerNinja54; 29-09-2021 at 09:05 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford Triac Spindle Issue
By GingerNinja54 in forum Denford MillsReplies: 1Last Post: 21-09-2021, 10:58 PM -
WANTED: Denford triac lynx spindle drive board
By mark35gun in forum Items WantedReplies: 4Last Post: 10-01-2021, 02:38 PM -
Denford Triac Spindle control / ATC
By RocketBoy in forum Denford MillsReplies: 21Last Post: 24-01-2018, 12:35 PM -
3kw Chinese Spindle - ER20 denford triac question
By andy_con in forum Denford MillsReplies: 13Last Post: 03-11-2015, 10:14 PM -
Denford Triac Spindle Fault
By Sam_Smith in forum Denford MillsReplies: 5Last Post: 04-05-2011, 11:07 PM
Bookmarks