X Axis Stall

[dazp1976]

You won't see a massive difference in speed with only 20V difference, if you want real speed with large 34 motors then you really need mains-powered drives. These give high speed and torque.

Probarbly not. Maybe an extra 400mm/min ish. Not much, but there'll be a lesser risk of skips/stalls if left at the present settings.
I was looking at the Leadshine DM2282 but..... For around another £100 I could get a basic 1kw AC servo set instead.
That's my future route so I'll make the most of what I've got until then.

[JAZZCNC]

I was looking at the Leadshine DM2282 but..... For around another £100 I could get a basic 1kw AC servo set instead.
That's my future route so I'll make the most of what I've got until then.

What mill have you got that you think a 1Kw servo is a correct choice.? I've got an Hurco BM40M milling machine that weighs 8 tons and is the size of a transit van that is only fit with 1.5Kw servos.. . Remember bigger doesn't; always make it better, often just more expensive with lower performance than a correctly sized motor.