-
12-10-2021 #1
Hi,
I am looking for some advice as I am experiencing some strange issue with a GRBL controller on a china 3040 CNC machine.
I had replaced the machine controller with GRBL board running DRV8825 drivers for all 3 axis.
I don't know the exact reason why, but the Z axis driver keep blowing up , and I have no idea what's going on.
wires seems ok, Arduino board runs fine (and replaced with another just in case) I did have some 'noise' on the motors (x and Y) and all wires are now with ferrite rings on (maybe that the issues?)
Would welcome some tip/advice of identifying the issue and if all else fail a new controller board that can drive the machine properly.
Adding some images, not sure if its any help.
Thanks in advance and sure am looking forward to any help that can be offered.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Issues with stepper motors losing power
By Steven W in forum General ComputingReplies: 14Last Post: 22-07-2021, 07:48 AM -
WANTED: Conqueror Design stepper driver or stepper conversion board
By pistolknight in forum Items WantedReplies: 1Last Post: 25-05-2019, 11:57 AM -
How do I wire a stepper driver to a stepper motor?
By swood1 in forum Stepper & Servo MotorsReplies: 7Last Post: 21-09-2014, 05:40 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
Which stepper driver
By Colin Barron in forum Motor Drivers & ControllersReplies: 0Last Post: 25-09-2010, 08:33 PM
Bookmarks