Matts. I have a Denford Starmill converted to linuxcnc (or mach3 if you prefer but linuxcnc Is far better) with a nice slim line PC and 15” tft screen
It is a in its original Denford case and other than one very small tool mark on the bed is extremely clean
It comes with the original Denford electronics cabinet and is set up for probing
It is a heavy sturdy mill but I transported it in the back of an Audi A2. It is a two man lift to move it
The spindle is R8 which means there are a lot of tooling options available and all cheap, I used collet chucks and I will let one go with the machine but you would need to buy your own set of collets R25 or R32 I can’t recall under £30 for a set or just buy the specific collet you need for your tool dia size
I’ve machines ally. steel, brass, plastics and stainless steel on it with out any problems
Email me at. paul at whittlefamily dot Co dot uk
Cheers. Paul


Sent from my iPhone using Tapatalk