-
31-10-2021 #1
I've just bought an 800w G-Penny spindle, and after some advice on the initial running-in process - as there is conflicting information online.
- The widely accepted minimum recommended frequency for the air cooled spindles is 120Hz (7,200rpm).
- The description on the AliExpress listing says to run in progressively from 3,000rpm.
- I messaged the seller and they said start from 100Hz (6,000rpm).
Am inclined to follow the sellers advice, but hoping for some real world experience to start me off on the right path! Thanks in advance..
-
31-10-2021 #2
Anything around 100Hz will be fine if you are just warming it up with no load, does it use steel or ceramic bearings.? Ceramic requires a little more warm-up time but can handle heavier loads.
-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
31-10-2021 #3
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Water cooled vs Air cooled spindle for wood
By Bucks in forum Machine DiscussionReplies: 5Last Post: 06-02-2017, 01:58 PM -
Where to buy 2.2Kw Water cooled spindle + VFD
By RocketBoy in forum Marketplace DiscussionReplies: 3Last Post: 01-08-2016, 12:38 PM -
Water cooled / air cooled 2.2kw spindle
By suesi34e in forum Generic Chinese SpindlesReplies: 15Last Post: 25-02-2015, 04:57 PM -
water cooled spindle
By alex wight in forum Generic Chinese SpindlesReplies: 1Last Post: 21-09-2012, 09:57 PM
Bookmarks