Quote Originally Posted by RobC View Post
12mm rails are going to be a bit of a sticky subject, what is your intended use/material etc. Normally those size rails you would find on a 3D printer which Is under very light axial/radial loads. Have you got a 3d design drawn up that we all could see?

Rob
Now then, erm plans. No!

I m kind of flying by the seat of my pants

Well, I am using someoe else's build from openbuilds

I have been told many times its not up to the job!

These builds based on oozenests workbee.

But, for some it may be of interest and some may not?

It may turn out OK, it may turn out to be awful?

Thanks

WoodKnot