Thread: step and dir pulse problem Mach3
-
05-02-2022 #11
-
05-02-2022 #12
To use the AXBB-E you will need 5Vdc and 24Vdc in the control box so you might need a PSU depending on what you have already. You can use 12Vdc in place of 24Vdc if don't have it, Some people use an old PC power supply that has both 5V and 12Vdc outputs.
Other than that all you need is an Ethernet cross-over Cable if running directly to PC or a standard Ethernet cable if running through a network hub or Switch.-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
05-02-2022 #13
-
I take it you have looked at Dean's website Web site: www.jazzcnc.co.uk
..Clive
The more you know, The better you know, How little you know
-
The Following User Says Thank You to Clive S For This Useful Post:
-
06-02-2022 #15
You don't always need a crossover network cable, a lot of network cards will do it automatically.
Sent from my COL-L29 using Tapatalk
-
06-02-2022 #16-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
06-02-2022 #17
-
08-02-2022 #18
Ordered the AXBB-E today, so looking forward to recieving and having a go setting it up, will post pics of the insides of the controller box i have tomorrow so people can tell me what i need and dont need and give me any help i need installing new card.
Cheers
-
09-02-2022 #19
The network card does the crossover automatically. You can use a normal patch lead IF your network card supports this function. We'll at least that's my setup.
I think the network option is called Auto-MDIX
Sent from my COL-L29 using Tapatalk
-
The Following User Says Thank You to Cube3 For This Useful Post:
-
09-02-2022 #20
Many do, yes. Likely get the odd packet loss which is not good for cnc even if slight.
However, why bother arguing with the user manual?.
It says use crossover when connected direct so why not do it?.
Not exactly expensive.
I made one from some cat7 bits I had.
Carefully set it all up and was moving in no time.
Thread Information
Users Browsing this Thread
There are currently 21 users browsing this thread. (0 members and 21 guests)
Similar Threads
-
Z axis out by 2mm mach3 or fusion360 problem?
By Richardtweed in forum Machine DiscussionReplies: 21Last Post: 01-05-2022, 08:41 PM -
Mach3 lathe spindle pulleys problem
By John11668 in forum Artsoft Mach (3 & 4)Replies: 32Last Post: 30-01-2021, 03:04 PM -
Small Mach3 Problem
By needleworks in forum General DiscussionReplies: 8Last Post: 11-05-2020, 10:46 AM -
Mach3 & V-Carve Problem
By Ricardoco in forum Computer SoftwareReplies: 2Last Post: 31-05-2013, 12:53 PM -
Mach3 small problem
By dudz in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 15-11-2012, 05:56 PM
Bookmarks