Thread: step and dir pulse problem Mach3
Hybrid View
-
06-02-2022 #1
You don't always need a crossover network cable, a lot of network cards will do it automatically.
Sent from my COL-L29 using Tapatalk
-
06-02-2022 #2-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
06-02-2022 #3
-
08-02-2022 #4
Ordered the AXBB-E today, so looking forward to recieving and having a go setting it up, will post pics of the insides of the controller box i have tomorrow so people can tell me what i need and dont need and give me any help i need installing new card.
Cheers
-
09-02-2022 #5
The network card does the crossover automatically. You can use a normal patch lead IF your network card supports this function. We'll at least that's my setup.
I think the network option is called Auto-MDIX
Sent from my COL-L29 using Tapatalk
-
The Following User Says Thank You to Cube3 For This Useful Post:
-
09-02-2022 #6
Many do, yes. Likely get the odd packet loss which is not good for cnc even if slight.
However, why bother arguing with the user manual?.
It says use crossover when connected direct so why not do it?.
Not exactly expensive.
I made one from some cat7 bits I had.
Carefully set it all up and was moving in no time.
-
09-02-2022 #7
This is what i have, what do i need and what do i have to take out....cheers
Just received my AXBB-E and i also got a 5v and 24v psu so all i need to do now is panic as i dont have a clue what im doing......Help
do i keep this board as it has the X Y Z axis attached
UPDATE.....Have connected Axbb-e to the 5v and 12v power psu and also connected network, so now need to build a bigger controller box so all will fit in.Last edited by mrmacca; 11-02-2022 at 05:50 PM.
-
13-02-2022 #8-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
-
13-02-2022 #9
-
13-02-2022 #10
My stepper motor has this on it NN MOTOR 57HS7416-15-14B 80 Does that mean anything , when I did a search it didn't come back with much except nema 23, so do i order drivers for a nema 23.
Cheers
Thread Information
Users Browsing this Thread
There are currently 10 users browsing this thread. (0 members and 10 guests)
Similar Threads
-
Z axis out by 2mm mach3 or fusion360 problem?
By Richardtweed in forum Machine DiscussionReplies: 21Last Post: 01-05-2022, 08:41 PM -
Mach3 lathe spindle pulleys problem
By John11668 in forum Artsoft Mach (3 & 4)Replies: 32Last Post: 30-01-2021, 03:04 PM -
Small Mach3 Problem
By needleworks in forum General DiscussionReplies: 8Last Post: 11-05-2020, 10:46 AM -
Mach3 & V-Carve Problem
By Ricardoco in forum Computer SoftwareReplies: 2Last Post: 31-05-2013, 12:53 PM -
Mach3 small problem
By dudz in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 15-11-2012, 05:56 PM
Bookmarks