. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 24-02-2022 #19
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by mrmacca View Post
    Back again , need help getting the spindle to spin in UCCNC, can move all axis but cant get spindle to move.
    Any ides much appreciated
    Simply connect Fwd to Gnd and it will start. If you want to start/stop it through the controller using UCCNC then use an Output which controls a relay and run a wire from Fwd through a NO contact back to Gnd on the VFD.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Z axis out by 2mm mach3 or fusion360 problem?
    By Richardtweed in forum Machine Discussion
    Replies: 21
    Last Post: 01-05-2022, 08:41 PM
  2. Mach3 lathe spindle pulleys problem
    By John11668 in forum Artsoft Mach (3 & 4)
    Replies: 32
    Last Post: 30-01-2021, 03:04 PM
  3. Small Mach3 Problem
    By needleworks in forum General Discussion
    Replies: 8
    Last Post: 11-05-2020, 10:46 AM
  4. Mach3 & V-Carve Problem
    By Ricardoco in forum Computer Software
    Replies: 2
    Last Post: 31-05-2013, 12:53 PM
  5. Mach3 small problem
    By dudz in forum Artsoft Mach (3 & 4)
    Replies: 7
    Last Post: 15-11-2012, 05:56 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules