Thread: Denford Triac Toolchanging Issue
Hybrid View
-
09-11-2021 #1
First check would be to see if the draw bar release cylinder is getting air. Just take the pipe off, and see if you get air out it when you activate the drawbar.
Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
-
10-11-2021 #2
Thanks m_c!
Out of interest, I have two regulators on the back of the cabinet; the upper one is connected and has a trap and lubricator fitted. The lower one is blanked off and doesn’t look to have ever been used?
Any ideas on if it should be?
The toolchanger/drawbar was working before, so the regulators aren’t causing this new issue, but I was wondering what the lower one is for?
Separately, my door has the pneumatic cylinder attached and it’s constantly under air pressure (when machine is connected to air) I assumed this should only be the case when it’s running?
I have to disconnect airline to open door!
Any ideas on this one too?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford Comms Issue (USB)
By GingerNinja54 in forum Milling Machines, Builds & ConversionsReplies: 3Last Post: 05-11-2021, 02:37 PM -
Denford Triac Spindle Issue
By GingerNinja54 in forum Denford MillsReplies: 39Last Post: 25-10-2021, 06:41 PM -
Denford Triac Spindle Issue
By GingerNinja54 in forum Denford MillsReplies: 1Last Post: 21-09-2021, 10:58 PM -
FOR SALE: Denford Triac PC inc Denford table plus chucks, and Denford CD software etc
By Piero franchi in forum Items For SaleReplies: 8Last Post: 14-02-2017, 04:47 PM -
Triac coordinate issue....we think!
By camhguh in forum Denford MillsReplies: 5Last Post: 10-12-2016, 12:19 AM
Bookmarks