Hybrid View
-
15-11-2021 #1
Stepper motors will quite happily run at 80degC.
Not being able to hold your hand on them after 45 minutes isn't of any concern. If they were getting that hot within 10-15minutes, I'd be concerned, but not after 45 minutes.Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Y axis problems
By Desertboy in forum General DiscussionReplies: 2Last Post: 22-12-2019, 11:04 PM -
Again Pokeys57CNC problems, anyone using it?
By Boyan Silyavski in forum PoLabs (PoKeys)Replies: 31Last Post: 13-09-2019, 05:35 PM -
CNC problems
By martythunder in forum General DiscussionReplies: 1Last Post: 15-02-2017, 08:10 PM -
Mach3 Problems problems problems.
By ECCO in forum Artsoft Mach (3 & 4)Replies: 18Last Post: 09-07-2016, 10:07 AM -
NEW MEMBER: MDF Problems
By MrWiz73 in forum New Member IntroductionsReplies: 4Last Post: 31-12-2011, 12:39 AM
Bookmarks