Thread: NVUM5-SP Power Supply
-
09-12-2021 #1
Hello everyone,
This is my first time building a CNC milling machine and I'm using NVUM5-SP controller. Does anyone know how i can power up the board?
Currently, I'm only using motor drive pins, limits+/-, emergency stop and tool probe pins. The limit switches are connected to 12V pins & and input pin, (eg. INP4)
The only pins that are left are "12V" , INP1, INP2. can i connect the power supply to these pins using INP1 as ground?
Attached is the wiring that's found in the manual.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NVUM5-SP power up
By xMahdix in forum Control Hardware & SystemsReplies: 0Last Post: 09-12-2021, 12:07 PM -
Which power supply to use
By Palletlad in forum General ElectronicsReplies: 20Last Post: 13-04-2018, 05:34 PM -
Power supply
By racerbear02 in forum Laser Machines & BuildingReplies: 0Last Post: 13-09-2015, 09:27 AM -
FOR SALE: power supply
By Web Goblin in forum Items For SaleReplies: 0Last Post: 14-09-2014, 03:19 PM -
Minimal-cost Power Supply Strategy - Repurpose Laptop Power Supplies
By LoveLearn in forum General ElectronicsReplies: 0Last Post: 25-01-2012, 09:29 PM
Bookmarks