. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 29-11-2010 #34
    Kwackers's Avatar
    Location unknown.
    Kwackers
    Last Activity: 21-10-2013 Has been a member for 9-10 years. Has a total post count of 29.
    Hi,

    Attached to this post V2.12b firmware.

    A couple of minor bug fixes, couple of minor new features and a change to the way the worm ratio is entered, rather than enter a worm ratio (and the device 'assume' a 400 step motor) you now enter the worm ratio multiplied by the step ratio.
    E.g for a 400 step motor and a 90:1 worm you'd enter 400 * 90 = 36000.

    This change allows odd ratios to be entered.
    I'll upload updated instructions shortly.
    Attached Files Attached Files
    Last edited by Kwackers; 29-11-2010 at 06:18 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Diy 4th axis rotary table using 100mm chuck with minimal backlash
    By kingcreaky in forum Linear & Rotary Motion
    Replies: 3
    Last Post: 05-09-2013, 01:03 PM
  2. Which chuck to fit 6" rotary table??
    By wiatroda in forum General Discussion
    Replies: 19
    Last Post: 10-08-2011, 08:47 AM
  3. Mounting a chuck on a Rotary table
    By irving2008 in forum Machine Discussion
    Replies: 17
    Last Post: 02-09-2010, 07:23 PM
  4. Rotary Table CNCing
    By irving2008 in forum Gantry/Router Machines & Building
    Replies: 21
    Last Post: 19-02-2010, 11:57 PM
  5. Setting up work on the rotary table
    By irving2008 in forum Machine Discussion
    Replies: 6
    Last Post: 09-01-2010, 10:27 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules