Threaded View
-
31-03-2009 #7
Last Activity: 05-11-2018
hi ;
the artwork did not work for me, and when I tried to make draw the circuit board , I found that
The PCB artwork shows 2 pins of the pot connected to ground and 1 pin to pin 3 of the LCD connector.
The Schematic shows 1 pin connected to ground, 1 pin to +5V and the other to pin 3 of the LCD connector.
can you please shed some light into it?
thanks
rasta
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Diy 4th axis rotary table using 100mm chuck with minimal backlash
By kingcreaky in forum Linear & Rotary MotionReplies: 3Last Post: 05-09-2013, 01:03 PM -
Which chuck to fit 6" rotary table??
By wiatroda in forum General DiscussionReplies: 19Last Post: 10-08-2011, 08:47 AM -
Mounting a chuck on a Rotary table
By irving2008 in forum Machine DiscussionReplies: 17Last Post: 02-09-2010, 07:23 PM -
Rotary Table CNCing
By irving2008 in forum Gantry/Router Machines & BuildingReplies: 21Last Post: 19-02-2010, 11:57 PM -
Setting up work on the rotary table
By irving2008 in forum Machine DiscussionReplies: 6Last Post: 09-01-2010, 10:27 AM
Bookmarks