CNC Rotary table/lathe head indexing

[Kwackers]

Hi Gianluca,

I'm unsure about how the proteus simulator works - however I should point out the movement is performed using interrupts - these are pretty rapid too (up to 10,000 per second). I'd guess that the simulator either can't handle interrupts or can't handle them at that speed.

Steve.

[Michel95]

Hi,
Thank you for sharing this project and sorry for my bad English. I would like to make a suggestion. I have noticed that when the motor is stopped the windings are not powered, so the shaft is free and can change position during normal use. It could be better to add the possibility to keep the driver activated in order to hold the shaft of the motor when it stops.
Regards
Michel