Thread: What’s Causing These Marks
Threaded View
-
27-01-2022 #4
Last Activity: 12-05-2024
I get them on passes like such, if you are not able to solve the issue leave a radial rough cut at say 0.1mm and come back with a finish pass at full depth to clean them up.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Plastic Chair Injection Molding Issue - White Marks
By steppenwolf in forum Moulding MachinesReplies: 3Last Post: 14-04-2022, 04:20 AM -
Opto isolated Bob and drivers causing a strange fault.
By lucan07 in forum General ElectronicsReplies: 2Last Post: 02-05-2016, 09:28 PM -
Roundover finishing - what's causing this..?
By Wal in forum Woodwork DiscussionReplies: 4Last Post: 18-03-2014, 03:37 PM -
New Computer Causing Me A Big Problem
By audioandy in forum Computer HardwareReplies: 26Last Post: 17-08-2010, 09:12 PM
Bookmarks