. .
  1. #1
    God bless You,
    After I had set up Mach3 to use Proma THC 150, plasma torch has stopped cutting material. Not even turning torch on manually by clicking F5 works. Previously it worked. By the way, I use AXBB-E to control plasma cutter.
    What should I change in Mach3 configuration to fix problem?
    Sincerely,
    JBL_LG
    Last edited by JBL_LG; 28-01-2022 at 07:30 PM.

  2. #2
    God bless You,
    I have found solution. Relay for torch hasn't been working, so it gets replaced with another one. Torch is working now.
    Sincerely,
    JBL_LG

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FOR SALE: some plasma stuff : Neuron Lite Plasma THC and Thermal Dynamics SL100 torch
    By Boyan Silyavski in forum Items For Sale
    Replies: 9
    Last Post: 10-08-2020, 12:09 PM
  2. Plasma Torch height setup required
    By Yorkshirerapper in forum Artsoft Mach (3 & 4)
    Replies: 0
    Last Post: 08-11-2017, 03:26 PM
  3. Proma elektronika torch height controler any good
    By whensparksfly in forum General Electronics
    Replies: 3
    Last Post: 06-03-2016, 01:17 AM
  4. FOR SALE: 3 sets of 4 xl pulleys and a plasma machine torch
    By nobby in forum Items For Sale
    Replies: 0
    Last Post: 20-05-2014, 07:33 PM
  5. Plasma, Mach3, Sheetcam and a Proma Torch height controller..
    By Davek0974 in forum Plasma Table Machines
    Replies: 2
    Last Post: 14-04-2014, 03:49 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •