-
27-01-2022 #1
God bless You,
After I had set up Mach3 to use Proma THC 150, plasma torch has stopped cutting material. Not even turning torch on manually by clicking F5 works. Previously it worked. By the way, I use AXBB-E to control plasma cutter.
What should I change in Mach3 configuration to fix problem?
Sincerely,
JBL_LGLast edited by JBL_LG; 28-01-2022 at 07:30 PM.
-
07-02-2022 #2
God bless You,
I have found solution. Relay for torch hasn't been working, so it gets replaced with another one. Torch is working now.
Sincerely,
JBL_LG
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: some plasma stuff : Neuron Lite Plasma THC and Thermal Dynamics SL100 torch
By Boyan Silyavski in forum Items For SaleReplies: 9Last Post: 10-08-2020, 12:09 PM -
Plasma Torch height setup required
By Yorkshirerapper in forum Artsoft Mach (3 & 4)Replies: 0Last Post: 08-11-2017, 03:26 PM -
Proma elektronika torch height controler any good
By whensparksfly in forum General ElectronicsReplies: 3Last Post: 06-03-2016, 01:17 AM -
FOR SALE: 3 sets of 4 xl pulleys and a plasma machine torch
By nobby in forum Items For SaleReplies: 0Last Post: 20-05-2014, 07:33 PM -
Plasma, Mach3, Sheetcam and a Proma Torch height controller..
By Davek0974 in forum Plasma Table MachinesReplies: 2Last Post: 14-04-2014, 03:49 PM
Bookmarks