Hybrid View
-
08-02-2022 #1
God bless You,
when THC function is enabled by clicking "THC" button in Mach3, torch lowers itself down, jet starts cutting and then everything stops. Torch doesn't move, jet doesn't cut. By the way, only THC UP and THC DOWN outputs are connected to AXBB-E. What should I change in Mach3 or Proma THC 150?
Best regards,
JBL_LG
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Leadshine EM drive tuning/enabling Q
By m_c in forum Motor Drivers & ControllersReplies: 3Last Post: 22-11-2016, 01:48 AM -
Plasma, Mach3, Sheetcam and a Proma Torch height controller..
By Davek0974 in forum Plasma Table MachinesReplies: 2Last Post: 14-04-2014, 03:49 PM -
What is the function of a parallel port breakout board?
By hbx in forum Machine Control SoftwareReplies: 13Last Post: 12-03-2013, 06:18 PM -
Homing switches & 'methods of working' (Mach3)
By HankMcSpank in forum Artsoft Mach (3 & 4)Replies: 15Last Post: 19-10-2012, 12:54 AM -
Mach3 and its enable function
By GeorgeD in forum Artsoft Mach (3 & 4)Replies: 0Last Post: 12-07-2010, 09:47 PM
Bookmarks