Help Mach3

[Mikes Planes]

Hi,
I bought a DM556T I now have all axis working OK so I will buy the other three I need.
Do I need to have a 5v power supply to each one or can I just use the 5v from the board??

Mike

[dazp1976]

Hi,
I bought a DM556T I now have all axis working OK so I will buy the other three I need.
Do I need to have a 5v power supply to each one or can I just use the 5v from the board??

Mike

Wire it as per the diagram in the image here:
Red and blue is the same to all drivers. Then pul/dir to chosen axis pins.
https://i.pinimg.com/736x/2a/05/34/2...179bfb9f8b.jpg

There is a pdf users manual here if still using that generic 5 axis board with relay:
https://warp9td.com/images/BOB_Vendo...line/ST-V2.pdf