. .

Thread: Help Mach3

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 13-07-2022 #1
    Mikes Planes's Avatar
    Lives in Les Alleud, France.
    Mikes Planes
    Last Activity: 01-03-2024 Has been a member for 3-4 years. Has a total post count of 45.
    Hi Just put the Y axis on the X axis and get the same problem only driving in one direction??

    Mike
    Reply With Quote Reply With Quote
  2. 13-07-2022 #2
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by Mikes Planes View Post
    Hi Just put the Y axis on the X axis and get the same problem only driving in one direction??

    Mike
    Check the wiring, check the pin numbers, check the cable, and after this then difficult to say without being in front of the machine. Personally, I would get rid of the parallel port and upgrade to an Ethernet-based controller as the parallel port is a dinosaur.!
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules