Quote Originally Posted by Mikes Planes View Post
Hi All,
Thank you all so much for your help. I don't seam to be getting anywere with what I have, I can get full movement on Y axis using Z port on the settings I was using??
If my breakout board is OK then what drivers should I buy??
I am so upset with all this as when we left UK it was running so well. I dont have the money to buy a new Geko and even if I did I have a deep feeling it would not fix things and I would be where I am now but having spent lots of money.
Thanks again guys you have all been a help.

Mike
DAFT QUESTION.
Do you have all 6 motor wires connected to TB6600?.
Because, if you look at the pdf's in post 33. All 6 wire configurations show 2 wires are disconnected. Only 4 are used on 4 wire drivers.