-
14-02-2022 #1
God bless You,
I have connected "ARC Ok", "ARC Up" and "ARC Down" outputs to AXBB-E. During cutting torch moves up and down for a while.
Then torch doesn't cut or move and measured voltage in THC rises until 3 hyphens show up.
Here are Proma THC 150 parameters:
- delay time: 1 s,
- hysteresis voltage: 2 V,
- high voltage (voltage of main/cutting arc): 200V.
And SheetCam parameters:
- feed rate: 1500 mm/min,
- pierce delay: 0.5 s,
- plunge rate: 1250 mm/min.
Material thickness is 2 mm. I think I should change pierce delay and delay time.
What else (if anything) must I change to make torch cut with reaction to detected height?
Sincerely,
JBL_LG
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Lost parameters '.dat' file for Spartan PJCM1325-1
By therailwayshop in forum CAD & CAM SoftwareReplies: 0Last Post: 17-09-2021, 04:46 PM -
HELP! Colchester CNC 350 + Fanuc Series O-T Parameters - Diagnostics
By Constantin in forum Lathes, Lathe Rebuilding & ConversionsReplies: 1Last Post: 26-08-2019, 05:38 AM -
Plasma, Mach3, Sheetcam and a Proma Torch height controller..
By Davek0974 in forum Plasma Table MachinesReplies: 2Last Post: 14-04-2014, 03:49 PM -
Optimize parameters for mills with tips
By hoezap in forum Tool & Tooling TechnologyReplies: 0Last Post: 15-06-2013, 01:18 PM -
G4 Dwell parameters
By mmcp42 in forum Programmers CornerReplies: 10Last Post: 31-12-2010, 04:49 PM
Bookmarks