Threaded View
-
20-02-2022 #3
Last Activity: 14-10-2023
I'm worried about hitting the end stops again. I damaged a ball screw on the x slide which cost me.
There is a proximity switch on the z axis which works well. I'm using mach4, it maybe that I can do it in the software but I haven't worked it out yet.
Regards
Steve
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Proximity switches or limit switches
By chillybo in forum Gantry/Router Machines & BuildingReplies: 52Last Post: 29-06-2021, 11:50 AM -
Boxford pull studs for vmc190 tool holders
By depronman in forum Tool & Tooling TechnologyReplies: 5Last Post: 01-11-2020, 12:23 PM -
limit switches on cnc
By dfox1787 in forum General ElectronicsReplies: 4Last Post: 11-01-2018, 04:20 PM -
EMC2 home/limit switches... only acting as limit?
By vputz in forum LinuxCNC (EMC)Replies: 4Last Post: 15-10-2014, 09:51 AM -
Boxford VMC190 Retrofit Problems, axis sounds very rough
By mikegolding in forum Boxford Vertical MillsReplies: 5Last Post: 09-06-2013, 09:11 PM
Bookmarks