Threaded View
-
01-04-2022 #7
Last Activity: 01-04-2022
Sorry for the delay responding chaps, had a rush job on which I just "ran by ear". Only cutting perspex so ran a scrap through at what I thought sounded right, checked it cut okay, and got the job done.
I've since had a play with the VFD settings and for PN01
1 - the display shows Hertz.
To display RPM you set PN01 to the maximum speed of the spindle. In this case I've assumed 24000rpm
To prove it, with PN01 set to 1, I then set the speed to 100Hz.
Then set PN01 to 24000 and ran the VFD.
Display then showed 6000 (rpm)
So I'm set now, and hopefully this thread may help anyone else who is confused the manual!
-
The Following User Says Thank You to Smiffy For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Single phase input variable frequency inverters XSY-AT1
By oldshooter in forum Motor Drivers & ControllersReplies: 12Last Post: 31-07-2020, 08:04 PM -
Suggested PWM frequency for a minimal Novamill conversion
By GND in forum Denford MillsReplies: 5Last Post: 04-04-2020, 12:50 AM -
High frequency vfd 1500hz
By assadi in forum Spindles & Drive MotorsReplies: 0Last Post: 28-08-2018, 04:12 PM -
Configuring Altivar 12 frequency regulator for PID control
By vesilp in forum Spindles & Drive MotorsReplies: 4Last Post: 28-01-2017, 04:26 PM -
Display bezel
By Robin Hewitt in forum General ElectronicsReplies: 1Last Post: 18-08-2009, 12:09 PM
Bookmarks