Very mysterious dropping steps on one Y axis motor...I'm starting to lose it!!

[Cube3]

Many moons ago I used that board and had missing step issues. I put it down to the speed of the opto isolators, but couldn't say for certain.I then used a board from CNC4YOU which was a lot better and worked ok in Mach3 and had 10v PWM for the VFD.

I finally got fed up with Mach3 and bought the AXBB and wouldn't go back. I can now run my toolpaths without babysitting the machine and hovering over the emergency stop button. Very confident with UCCNC.

Sent from my SM-A715F using Tapatalk

[dazp1976]

Many moons ago I used that board and had missing step issues. I put it down to the speed of the opto isolators, but couldn't say for certain.I then used a board from CNC4YOU which was a lot better and worked ok in Mach3 and had 10v PWM for the VFD.
I finally got fed up with Mach3 and bought the AXBB and wouldn't go back. I can now run my toolpaths without babysitting the machine and hovering over the emergency stop button. Very confident with UCCNC.
Sent from my SM-A715F using Tapatalk

Same.
Although went the UC300eth and UCBB route.

I did however have zero issues with the 5 axis parallel board and mach3 at 35,000 khz.
Will be re-using it on uc300eth port#3 for switching some relays.