Roland MDX-30

[Portland Jon]

I've finally sorted the problem with the drivers. It seems that the driver is incompatible with the UEFI file system that has been in use since Windows 7. I didn't know what UEFI was until yesterday but now I do. I had to delete the system partition on my PC then convert it back to the old style MBR (Master Boot Record) system. Then so the system could see it I set the BIOS to boot into Legacy Mode. Then it's plain sailing to install Windows 7, I used Windows Ultimate x64. Once it was installed I connected the MDX-30 via USB and turned it on. Windows saw it and installed it as TS-30 unknown device. Then I extracted the .zip driver file from Rolanddga website into a folder and in Devices and Printers updated the driver to the MDX-40 one. Windows grumbles about it but click Use this driver anyway and all went well.

That's about where I am at now but I have installed Dr Engrave from Rolanddga and sent it to the machine. I didn't set the tool depth but the tool spun and the machine carved out a test pattern in the air above the work piece.

Sent from my ELE-L09 using Tapatalk

[aqibi2000]

I've finally sorted the problem with the drivers. It seems that the driver is incompatible with the UEFI file system that has been in use since Windows 7. I didn't know what UEFI was until yesterday but now I do. I had to delete the system partition on my PC then convert it back to the old style MBR (Master Boot Record) system. Then so the system could see it I set the BIOS to boot into Legacy Mode. Then it's plain sailing to install Windows 7, I used Windows Ultimate x64. Once it was installed I connected the MDX-30 via USB and turned it on. Windows saw it and installed it as TS-30 unknown device. Then I extracted the .zip driver file from Rolanddga website into a folder and in Devices and Printers updated the driver to the MDX-40 one. Windows grumbles about it but click Use this driver anyway and all went well.

That's about where I am at now but I have installed Dr Engrave from Rolanddga and sent it to the machine. I didn't set the tool depth but the tool spun and the machine carved out a test pattern in the air above the work piece.

Sent from my ELE-L09 using Tapatalk

Thanks a lot for posting this, you have sparked my interest for getting my MDX-40A running again! I'm struggling to locate the VPanel Installer for my machine (there is only an update package 1.1V flying around on the internet.:(