Thread: HY VFD DCM connection
Hybrid View
-
09-05-2022 #1
Thanks for the comments. My main concern was about the isolation of DCM inside the VFD but overnight it occurred to me that if I just check volts between FOR and DCM (expecting 12-24v or so), then both to control box ground, I can get some idea whether or not they are isolated. And if all else fails, I stick a relay in there. I've just found that I need to get a 16-pin IDC connector to pick up the analogue output on the UC300 as they don't provide that as part of the kit so things are going to be a little delayed anyway.
I have a copy of the manual - it's good that they show a circuit diagram of the board's interfaces. Gives a bit more insight into what's going on under the covers!
-
09-05-2022 #2
You can use Dupont 2.54mm wires/ connectors directly on the UC300eth IDC pins.
VFD FOR - DCM is just a ground sinking line.
External relay (or opto module) is needed to control it, COM/NC to make or break that single line (on/off).
See my posts of this cncdrive thread:
http://www.forum.cncdrive.com/viewto...=3780&start=30
There are some wiring diagrams on page3 and images on page4
Diagram here too:
http://www.forum.cncdrive.com/viewtopic.php?f=19&t=3829
Shows connecting relay via Bob and also dupont uc300 direct.
Has AO1 wires too.
(your vfd may differ slightly)Last edited by dazp1976; 09-05-2022 at 12:06 PM.
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Xsy-at1 connection translation
By GREG021 in forum Motor Drivers & ControllersReplies: 4Last Post: 17-02-2021, 02:10 PM -
Which Connection ?
By manofgresley in forum Stepper & Servo MotorsReplies: 17Last Post: 13-07-2020, 01:55 PM -
Connection hub
By Agathon in forum General ElectronicsReplies: 9Last Post: 18-05-2020, 09:06 PM -
smoothstepper with ethernet connection
By terry1956 in forum Motor Drivers & ControllersReplies: 15Last Post: 22-02-2016, 03:22 PM -
Or Guidance ;) Connection Name(s)
By Carlb1058 in forum Marketplace DiscussionReplies: 6Last Post: 13-07-2013, 12:48 AM
Bookmarks