Threaded View
-
12-05-2022 #1
Hi, I have three Panasonic MSD043xx servos on a Triac I am rewiring. It had a AHHA Artisan Dos system on it before with their propriety boards wired in. So had to remove all of those.
Anyhoot with a lot of help (thanks to joe.average and Andrew over at the Warp9 forum). I have managed to sort out the wiring in theory. However the manual states the pins numbers but not how they relate to the actual connection on the unit. The connection looks like an SCSI 36 pin.
I am thinking that this may be the case (below), but would like confiirmation either way please.
The manual also has a diagram... that I think might be a optional cable connection for the unit????? The image with the trapeziode seems to denote a connector but doesn't seem to follow any known configuration?????
I have the original "pre-made" cables, but I feel these may be a special cable for the AHHA/Artisan boards??? (again guessing). They are labelled "Simplatroll M2-544854" but I cannot find any information on these.
Any information would be gratefully recieved
thanksEvery time I am wrong - the World makes a little less sense.
Thread Information
Users Browsing this Thread
There are currently 9 users browsing this thread. (0 members and 9 guests)
Similar Threads
-
MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help
By Nemo1966 in forum Stepper & Servo MotorsReplies: 26Last Post: 22-05-2022, 05:58 PM -
MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help
By Nemo1966 in forum General DiscussionReplies: 2Last Post: 27-08-2020, 07:54 PM -
Dc servo driver
By Treemonkey in forum Motor Drivers & ControllersReplies: 11Last Post: 11-02-2013, 08:16 PM -
Panasonic 3 phase driver running on 1 phase?
By gavztheouch in forum Motor Drivers & ControllersReplies: 2Last Post: 10-05-2012, 11:21 PM -
FOR SALE: 400w panasonic ac brushless servo motors and drives
By gavztheouch in forum Items For SaleReplies: 3Last Post: 29-12-2011, 03:04 PM
Bookmarks