Hybrid View
-
12-05-2022 #1
A bit like this one which is a db44 for a delta.
https://www.aliexpress.com/item/1005...c00PlsAmK&mp=1
The loose ends get connected to the relevant pins on your breakout/controller you want to use to control it.
Looks like a 36pin scsi on the panny to me.
Something like this and chop it to loose one end (depending on whether need male/female).
https://www.aliexpress.com/item/4001...Adapt=Pc2Msite
Or solder your own 'kit' connector together.
https://www.aliexpress.com/item/3304...Adapt=Pc2MsiteLast edited by dazp1976; 12-05-2022 at 10:03 PM.
-
12-05-2022 #2
-
12-05-2022 #3
In short... is this correct or not?????
Attachment 31027Every time I am wrong - the World makes a little less sense.
-
12-05-2022 #4
-
12-05-2022 #5
Ok, can you post the manual or a link to it.
-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
Thread Information
Users Browsing this Thread
There are currently 8 users browsing this thread. (0 members and 8 guests)
Similar Threads
-
MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help
By Nemo1966 in forum Stepper & Servo MotorsReplies: 26Last Post: 22-05-2022, 05:58 PM -
MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help
By Nemo1966 in forum General DiscussionReplies: 2Last Post: 27-08-2020, 07:54 PM -
Dc servo driver
By Treemonkey in forum Motor Drivers & ControllersReplies: 11Last Post: 11-02-2013, 08:16 PM -
Panasonic 3 phase driver running on 1 phase?
By gavztheouch in forum Motor Drivers & ControllersReplies: 2Last Post: 10-05-2012, 11:21 PM -
FOR SALE: 400w panasonic ac brushless servo motors and drives
By gavztheouch in forum Items For SaleReplies: 3Last Post: 29-12-2011, 03:04 PM
Bookmarks