Quote Originally Posted by Nemo1966 View Post
The rows in the manual don't make sense as explained previously in my last reply to JAZZCNC.

Also found this https://www.ebay.com/itm/30385701666...gAAOSwAxtgCptv

The fact that this guy in the USA is selling generic cable for Yaskawa, Mitsubishi, Panasonic servos would also suggust to me a standard pin numbering for the port.

Click image for larger version.  Name: panni_pic02.jpg  Views: 202  Size: 172.7 KB  ID: 31040
Ok, now I can see the connector properly I can tell you that it's exactly the same connector as the pics I posted.

So in your original post, the 2nd pic is correct if viewed from the front. BUT the manual diagram is also correct when viewed from the rear of the connector as you would normally wire the connector.