Threaded View
-
24-05-2022 #1
OK so got 3 of these on a Denford Triac. Trying to get them running (nearly there) but the manual is driving me insane.
In this picture (from the manual)...
So in the picture I assume it shows the starting state of the servo connections before the "Trial Run". (page 24 - 25 in the manual)
It shows:
"Servo ON" as OFF (open switch)
"CL" as ON (closed switch)
"INH" as OFF (open switch)
[B]
But then in the instructions it states - "Make a deviation counter clear (CL) signal to clear release (L -> H)."???? So I am assuming the "ON" state at the start is "LOW". I would have assumed "LOW" was OFF ?????
Also when it says signal to clear release - I assume this is flip the switch???? Not flip it on and off to reset a counter????
Do I have to run through this procedure everytime I start the servos??? Seems strange.
Anyone please... the manual is driving me nuts.?
Thanks
Manual -> https://www.airgunownersclub.co.uk/d...s_manual_e.pdfLast edited by Nemo1966; 24-05-2022 at 03:48 PM.
Every time I am wrong - the World makes a little less sense.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help
By Nemo1966 in forum Stepper & Servo MotorsReplies: 26Last Post: 22-05-2022, 05:58 PM -
Panasonic MSD043Axxx Servo Driver pin outs????
By Nemo1966 in forum Motor Drivers & ControllersReplies: 22Last Post: 14-05-2022, 06:18 PM -
MSD043A1XXV Panasonic AC Servo Driver 400w - MB3 connection help
By Nemo1966 in forum General DiscussionReplies: 2Last Post: 27-08-2020, 07:54 PM -
Driving me insane
By Bush Flyer in forum Motor Drivers & ControllersReplies: 17Last Post: 14-04-2014, 03:55 PM -
FOR SALE: 400w panasonic ac brushless servo motors and drives
By gavztheouch in forum Items For SaleReplies: 3Last Post: 29-12-2011, 03:04 PM
Bookmarks