Threaded View
-
07-05-2015 #30
Not so simple. First you need to know the moving mass. Then the desired speed and acceleration. Then you decide the motors and the ratios. Then you check if your BOB can cope with that. Then you check what your resolution will be. Some back and forth between all that and a final decision. At least that's my logic.
Last edited by Boyan Silyavski; 07-05-2015 at 02:03 PM.
Thread Information
Users Browsing this Thread
There are currently 12 users browsing this thread. (0 members and 12 guests)
Similar Threads
-
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
Simple Solution- Drive 1" Ball Screw Shaft with NEMA-23-Size Stepper Motor Shaft
By LoveLearn in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 08-02-2012, 01:52 AM -
Stepper shaft size and pulley bore size problem
By psiron in forum Linear & Rotary MotionReplies: 13Last Post: 15-06-2010, 04:11 PM -
Motor size
By Philmollatt in forum Motor Drivers & ControllersReplies: 8Last Post: 15-10-2009, 08:39 PM -
What stepper motor size (torque)
By ZeroCount in forum Stepper & Servo MotorsReplies: 5Last Post: 09-02-2009, 11:54 PM
Bookmarks