What size stepper motor do I-need.

[Boyan Silyavski]

I am going to use PoStep60-256 drivers and 48V PSU.

the motors that they sell at the same place http://www.poscope.com/nema23 are the same motors that zappautomation or cnc4pc sells. That are the motors that most people drive at 70V with Leadshine drives.
I also am looking at that drive you say, plus they have new 8axis ethernet board. Just today wrote them a big letter asking them many things about the board and the drives.

What i am saying is that when looking at the pdf of the motors StepperMotorDimensionsNema23.pdf the torque curve driven at 60V or 40V is very same till 3000rpm, hence 4 motors can be driven by 2x35VAC toroid 500w, which rectified will give ~49VDC, which is very near the drive capability /50VDC 6A/ . One of the questions i asked is if really this drive could drive the motor with this setup, i expect they will answer me tomorrow.

What i say is that will be better than the motor you say.