-
28-07-2022 #21
Update:
I removed the stepper motor and tried moving it unloaded - same problem
SIEG gave me some further tests to put the software in debug mode and disconnecting the motor from the driver - same problem in that the software hangs at the same point
Therefore it looks like a controller fault.
Regards a simple motion controller for rotating an ATC only which might be the best route:
Mach3 demo (since limited code would be required) with a Mach3 card like:
https://www.amazon.co.uk/Motion-Cont...NsaWNrPXRydWU=
or an Arduino controller with some development
-
28-07-2022 #22
.
Last edited by Doddy; 28-07-2022 at 05:44 PM.
-
28-07-2022 #23
To me it sounds like the controller is hanging waiting for something to happen (and pretty rubbish programming, in that it locks up rather than timing out).
Are there any sensors on the turret?
And is there anything connected to the Origin terminals on the driver?Avoiding the rubbish customer service from AluminiumWarehouse since July '13.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Sieg mini lathe cnc conversion need help
By diddly in forum Sieg LathesReplies: 0Last Post: 20-12-2014, 10:53 AM -
Chester MF42B Lathe Wiring Issues
By kingcreaky in forum General ElectronicsReplies: 5Last Post: 18-02-2013, 02:21 PM -
FOR SALE: Sieg C3 Mini Lathe
By Jonathan in forum Items For SaleReplies: 1Last Post: 07-05-2011, 06:19 PM -
WANTED: SIEG C3 Mini Lathe
By derekm in forum Items WantedReplies: 5Last Post: 07-04-2010, 08:35 PM -
WANTED: SIEG C3 Mini Lathe WANTED
By derekm in forum Items WantedReplies: 0Last Post: 03-08-2009, 03:02 PM
Bookmarks