Nema 34 stepper motor.

[dazp1976]

Thank for information. Ok. I have paired the 8 wires to make 4 pairs. However unlike a 4 wire motor I can’t find which of the pairs go together as I am not getting any feedback from the ohm meter. So I am unsure how to pair up the 4 sets. Also the DM860T driver needs by the look of it a lot more voltage then my 24 volt power supply can give out. So what do I need to do here.

Nema34 on a 24v is a no go. Having a laugh there. It will be total crap. You will get hardly any max velocity.
Voltage V gives you speed.
Current A gives you torque.
24v+,= nema17
36v+,= nema23/24
60v+,= nema34

What is the model number on the nameplate of the motor (if it's there).

Nema 23/24 are the nuts on drivers supplied with 60vdc.
Nema34 are miles better on drivers supplied at least 80vdc

Edit: most if not all nema34 have 14mm shafts.
Are you sure you don't mean nema24!?