Hybrid View
-
14-08-2022 #1
Last Activity: 15 Hours Ago
I hate to say this but I would go over to the linuxcnc forum and look at QTplasmaC forum.
And use Linuxcnc with a a Mesa 7i96s with a Mesa THC10 for torch height controller..Clive
The more you know, The better you know, How little you know
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello, Newbie seeking advice.
By Lodds in forum New Member IntroductionsReplies: 3Last Post: 22-07-2017, 04:04 PM -
NEW MEMBER: New member seeking advice from those in the know
By jonny5 in forum New Member IntroductionsReplies: 0Last Post: 04-02-2017, 06:58 AM -
NEW MEMBER: Hi all - Seeking advice for a new project
By julian in forum New Member IntroductionsReplies: 3Last Post: 23-06-2012, 02:53 PM -
NEW MEMBER: New member seeking advice
By Rob Wol in forum New Member IntroductionsReplies: 14Last Post: 02-02-2012, 10:54 PM -
NEW MEMBER: New member from Suffolk/Essex/Cambridge
By richb77 in forum New Member IntroductionsReplies: 6Last Post: 18-10-2008, 12:04 PM
Bookmarks